Tweet
Hello All,
Seeking some insight on an issue with a Ernemann 15 16mm Projector.
There is an issue with the projector engaging tension when the film is threaded. After threading up the arms do not lock into place when engaging the tension by turning on the switch. I also noticed the lower area spindle you put the reel on(i do not have know the exact name of it) turns on its own very slowly at all times. Any ideas on what the issue could be? Let me know. I am assuming a board went bad or something needs to be tweaked.
Seeking some insight on an issue with a Ernemann 15 16mm Projector.
There is an issue with the projector engaging tension when the film is threaded. After threading up the arms do not lock into place when engaging the tension by turning on the switch. I also noticed the lower area spindle you put the reel on(i do not have know the exact name of it) turns on its own very slowly at all times. Any ideas on what the issue could be? Let me know. I am assuming a board went bad or something needs to be tweaked.