Tweet
Hi there!
Recently i did some installation and as always when doing with all ready installed light system, curtain etc I do use my own development controller. As there is AP25 in booth I went to use automation buttons, so they can control stuff, to avoid adding another panel. To make things short, when some press buttons it sends command true TCP to my controller to do something, at moment of pressing button becomes green and than get back to gray. So, my controller does have response either control was success or no and sends it back. So, I am interested can i trigger somehow status that if response was OK that button stays green, or if not, it get back to gray.....
I did check manual but did not have found anything like that.....other option, that just cross my mind is that i configure MACRO with same name as my response and every time I get response to set variable to 1, than I need to have something which will change status of button, color would be ok, or even text......
Recently i did some installation and as always when doing with all ready installed light system, curtain etc I do use my own development controller. As there is AP25 in booth I went to use automation buttons, so they can control stuff, to avoid adding another panel. To make things short, when some press buttons it sends command true TCP to my controller to do something, at moment of pressing button becomes green and than get back to gray. So, my controller does have response either control was success or no and sends it back. So, I am interested can i trigger somehow status that if response was OK that button stays green, or if not, it get back to gray.....
I did check manual but did not have found anything like that.....other option, that just cross my mind is that i configure MACRO with same name as my response and every time I get response to set variable to 1, than I need to have something which will change status of button, color would be ok, or even text......
Comment