Welcome to the new Film-Tech Forums!
The forum you are looking at is entirely new software. Because there was no good way to import all of the old archived data from the last 20 years on the old software, everyone will need to register for a new account to participate.
To access the original forums from 1999-2019 which are now a "read only" status, click on the "FORUM ARCHIVE" link above.
Please remember registering with your first and last REAL name is mandatory. This forum is for professionals and fake names are not permitted. To get to the registration page click here.
Once the registration has been approved, you will be able to login via the link in the upper right corner of this page.
Also, please remember while it is highly encouraged to upload an avatar image to your profile, is not a requirement. If you choose to upload an avatar image, please remember that it IS a requirement that the image must be a clear photo of your face.
Thank you!
I have not looked at the JSD-80 in quite a while, but I believe you should set the Doremi to use a raw TCP interface and talk to the JSD-80 on port 10001. You should probably put \w before and after the command so the connection is not dropped before the JSD-80 has a chance to interpret it. A list of commands are at http://ftp.uslinc.com/Products/JSD-8...onCommands.pdf .
Alright I am having a bit of trouble with setting up a command. For example I’m trying to set the processor to non sync (button 6) I created a macro with the label non sync under the device name of my processor and the message type as text. So now, what is the syntax for getting the Doremi to set the input to the non sync input?Programming is not my forte so this stuff confuses me sometimes. Thanks
Thanks James! The JSD-60 and JSD-80 commands are substantially different. For the JSD-80, see http://ftp.uslinc.com/Products/JSD-8...onCommands.pdf . Of note on Doremi, a \w before and after the command help. The command should be terminated with \r .
What is the output resolution of one of the HD-SDI outputs set in 3D mode? Is it locked at 2k? I got my converter today and all I see on my display is static. Audio works. I’m assuming that the signal going in is to high a resolution for the converter to understand.
It is always 2048/1080. The converter will probably not have problems with this, but the display may. Unless there is active link encryption, which I suspect is the problem you see.
Tweet
Comment