It would appear that Barco has been busy. In 1.8.1, Mark II versions of quite a few projectors are now supported. I wonder what a Mk II version is...maybe with the new TRP chips? They also support the SP2K-20C and SP2K-25C.
They're getting their feet wet with the Post-Production world by releasing the SP4K-P projector and "Automatic Metameric Offset Correction on MGCD file." This is supposed to give the laser projector more of a xenon look, color wise.
Version 1.8.1 (Major release)
New feature:
• Support new projector model
o SP4K-P & SP4K-P+
o NERTHUS
o Support Mk II version of SP4K-12C / SP4K-15C / SP4K-20C / SP4K-25C / SP2K-20C / SP2K-25C
• Adapt white point calibration algorithm based on the green laser plates detected.
• WebCommunicator Postproduction version (software license needed) including :
o Support file management of LUT-DG, CSC file
o Create or edit TCGD file
o Save PCF file based on activated setting
o Automatic Metameric Offset Correction on MGCD file
o Video path control
• Logging of Lens position in a dedicated file
• Support Gamma settings on the media player input
• Picture page UI improvement
o Letterbox settings redesigned.
o Scaling value validation
o Virtual keyboard adaptation
• Sorting test pattern/ Macro based on the preset/shortcut position
• Improve White point target algorithm.
• Execute file from the Edition/creation page of the file
• Sorting by name or IP projector visible in the dashboard page
• See the existing configuration before to same a file Bug fixes:
• Fix an issue where fans were not spinning after a CCB exchange.
• Fix an issue where DHCP IP address was released right after the startup.
• Fix an intermittent issue where laser didn’t turn on after swapping a CCB between RGB and laser phosphor projector
Known issues:
• ICMP: HDR formats are not supported over HDMI.
They're getting their feet wet with the Post-Production world by releasing the SP4K-P projector and "Automatic Metameric Offset Correction on MGCD file." This is supposed to give the laser projector more of a xenon look, color wise.
Version 1.8.1 (Major release)
New feature:
• Support new projector model
o SP4K-P & SP4K-P+
o NERTHUS
o Support Mk II version of SP4K-12C / SP4K-15C / SP4K-20C / SP4K-25C / SP2K-20C / SP2K-25C
• Adapt white point calibration algorithm based on the green laser plates detected.
• WebCommunicator Postproduction version (software license needed) including :
o Support file management of LUT-DG, CSC file
o Create or edit TCGD file
o Save PCF file based on activated setting
o Automatic Metameric Offset Correction on MGCD file
o Video path control
• Logging of Lens position in a dedicated file
• Support Gamma settings on the media player input
• Picture page UI improvement
o Letterbox settings redesigned.
o Scaling value validation
o Virtual keyboard adaptation
• Sorting test pattern/ Macro based on the preset/shortcut position
• Improve White point target algorithm.
• Execute file from the Edition/creation page of the file
• Sorting by name or IP projector visible in the dashboard page
• See the existing configuration before to same a file Bug fixes:
• Fix an issue where fans were not spinning after a CCB exchange.
• Fix an issue where DHCP IP address was released right after the startup.
• Fix an intermittent issue where laser didn’t turn on after swapping a CCB between RGB and laser phosphor projector
Known issues:
• ICMP: HDR formats are not supported over HDMI.
Comment