August 2010 photos from the Tony Bandiera Jr collection.
118 KB · 625x469
Sign outside the room. The donor’s name has been blacked out... |
| 
112 KB · 436x625
The main entry with electronic video "marquee" abo... |
| 
112 KB · 625x469
At the top of the auditorium, with the room set up for "... |
| 
79 KB · 625x342
Looking into the projection booth from near the top of house... |
| 
105 KB · 625x424
A view from the stage. Surrounds are JBL 8330. Note the fabr... |
|
111 KB · 625x469
The so-called "Smart" Podium. The touchscreen allo... |
| 
73 KB · 625x350
The JBL Center and sub channel speakers on the stage, prior ... |
| 
94 KB · 469x625
Center/sub rear view showing the crossover and Speakon cable... |
| 
70 KB · 625x466
Connector panel on the stage rear wall for the speakers. The... |
| 
82 KB · 625x594
Screen controls on the stage. There is a duplicate set on st... |
|
87 KB · 625x469
The cinema screen down, with the maskings retracted in the s... |
| 
69 KB · 625x313
Screen with maskings set for Scope. |
| 
67 KB · 625x312
Screen with masking at 1.85 The 1.66 setting is about 2-3 ... |
| 
64 KB · 625x301
Screen with masking at 1.33/1.37 with RP-40 loop. Yes the p... |
| 
110 KB · 625x469
A shot of the lower level of the booth. The counter on the l... |
|
83 KB · 625x469
The 35mm Irem Rectifiers. They are behind the A/V rack shown... |
| 
115 KB · 469x625
The upper level of the booth, my exclusive domain since 1997... |
| 
118 KB · 469x625
The FP-38D, 35mm film side. BACP Reverse scan readers were ... |
| 
96 KB · 469x625
The FP-38D 16mm side. The picture this puts out is bright an... |
| 
90 KB · 625x469
The dual lamphouses on each machine. We run Christie CXL 16 ... |
|
118 KB · 469x625
35mm Optical thread-up. Kinoton purists will note that I hav... |
| 
102 KB · 469x625
DTS Digital thread-up. The use of the old 4-track mag path p... |
| 
112 KB · 625x469
Dolby Digital thread-up. I am extremely unhappy with my effo... |
| 
124 KB · 625x469
Another angle of the Dolby Digital threading. |
| 
61 KB · 625x353
Projector control panel I made some years ago. Before I had ... |
|
105 KB · 625x469
AMX Touchpanel film page. This is an older AXCESS series sys... |
| 
110 KB · 531x625
Top part of the film sound rack. From Top: Furman power con... |
| 
131 KB · 469x625
Middle part of film sound rack. Showing the ALTEC mixer for... |
| 
82 KB · 328x625
Bottom part of the film sound rack. Dolby CAT 363’s for the ... |
| 
142 KB · 625x469
Closer look at the Dubber Interface and Dolby CAT 363 frames... |
|
117 KB · 469x625
A closer look at the video gear. |
| 
101 KB · 469x625
Magna-Tech dual dubber with test reels one picture and one t... |
| 
86 KB · 619x625
Close up of the dubber Audio and encoder connector panel. I ... |
| 
81 KB · 625x469
The Sanyo video projector for all of my video. Coolest thin... |
| 
108 KB · 469x625
The room’s audio amps are all located in a room behind the ... |
|
93 KB · 321x625
Rear of amp rack showing the surround array wiring with dumm... |
| 
116 KB · 469x625
Dubber encoders mounted in the FP-38D’s. I fabricated the br... |
| 
159 KB · 469x625
A shot of the FP-38 control electronics mounted on the 16mm ... |
|
Home