Kelmar Arm SetScrew Size?

[Jim Cassedy]

Does anybody happen to know the size of the setscrew used on KELMAR 35/70mm reel arms?

I had a nice T-Handle driver the right size, but I can't seem to find it, so I might have to go get
another one, and I'm trying to determine the size. A rough measurement is 3/8in, but I'd like to
be sure if anyone knows. THANSK!

KelmarArmScru.jpg

[Ryan Gallagher]

If they are the same as the 35mm arm screw I can check after the holiday. But sure someone will chime in before then.

[Brad Miller]

3/8 inch allen

[Jim Cassedy]

THANKS, Brad. I sort of figured out that was the allen driver size last night, because a 10mm metric allen wrench was just a bit too large, and 3/8in was the closest non-metric wrench size, which made sense to me. The good news is that I found my T-handle 3/8in allen tool last night when I got home.