Tweet
We have a Christie Solaria One Plus projector. Is it possible to connect a DSS200 server to this projector? I tried to connect it, configured the DSS server according to the projector's IP settings, but I got the error message "error securing connection between show store and projector." Previously, we were using the server with a Barco 20c projector, and there was a Barco Enigma board to receive video signals. I think the issue might be due to this board. The board has two PCI Express-like slots, but Christie only has one slot for the server. I tried connecting it, and when I powered it on, the Enigma board received power and the LEDs lit up. When I connected the SDI cables, the LEDs also lit up. However, the DSS still showed the error "error securing connection between show store and projector." Is the DSS200 incompatible with the Christie Solaria One, or what should I do to make it work?
-
-
Not sure, but the projector will need a link decryptor module (Enigma) and I don't know if that's possible with the Solaria+. They used the Christie IMB server, which wasn't too great. I think they could use internal servers from Dolby or others but, again, don't know much about them. The SDI inputs are for alternative content from what I see in the documentation and don't have the required decryption capability.
On S2 Christies the LD module is mounted on the PIB. But note that a Barco module will not work except in a Barco projector, even though it's a TI unit and they all look the same. -
As Dave said, Christie LD module (with proper software, not the Barco one) is mounted on the PIB. But Solaria One PIB doesn't have LD slot populated nor SDI video input terminal at all, so DSS200 w/cat 862 is not compatible.Comment
-
hello eyüphan
DSS200 enigma card file works integrated, unfortunately solaria one enigma support is not available , Enigma support is available on Christie CP2210 and above models...Comment
Comment