Announcement
Collapse
No announcement yet.
Search Result
Collapse
96 results in 0.0051 seconds.
Keywords
Members
Tags
-
NEC NC900 failure
Hi, a colleague just called me about his NC900 issue that came up today. Until yesterday, everything was working okay with his Doremi DCP2K4 and NC900....Last edited by Carsten Kurz; 12-14-2024, 07:06 AM.
-
So ...
There is no internet available on that location. There used to be a public WIFI for some years, but that was always unstable, and...Last edited by Carsten Kurz; 12-16-2024, 07:16 AM.
-
By far, the ICP module, which has a lot of very low-current contacts (both sides) is the primary culprit. Some projectors have fared better than others....
Leave a comment:
-
Out of curiosity, I just ran this search: https://www.film-tech.com/vbb/search?q=reseat . I get 93 posts with the word "reseat." Are the board...
Leave a comment:
-
That is on the WAN side of things so the CPU (NEC's CCB) board might be able to talk to the outside but not to any of the LAN devices. I'd still start...
- Likes 1
Leave a comment:
-
It's a Christie! They all are starting to point to the PIB/signal backplane board on a typical Christie or its related wiring. There is also the off-chance...
Leave a comment:
-
Barco ICMP image slowed playback
I have very strange problem with barco 10s projector and ICMP (2nd generation). While playind dcp, no mater is it trailler, feature etc picture is kinda...
-
Huh? Did someone mention me?
First off...the IMB/IMS or Enigma (SDI based system) is the security manager for the projector. You will...
- Likes 1
Leave a comment:
-
Did you reseat any cables while you had the light engine compartment open? If so, that likely explains the DMD sensor error.
It should be...
- Likes 1
Leave a comment:
-
It should not fail. Under normal circumstances, once the marriage procedure has been done, it should not be broken unless a tamper detection switch is...
- Likes 1
Leave a comment:
-
I blame whatever card edge connector Barco is using on the signal backplane. NEC and Christie use the same ICP card and while they too do get to a "reseat"...
Leave a comment:
-
Remove PIB and clean PIB Contacts and Card cage, Reseat with marriage password.
Leave a comment:
-
If it's not the cable, I fear that this could be symptomatic of the projector's CCB failing, then. A contact clean and reseat can't hurt.
...
Leave a comment:
-
The cpu fan should be replaced but is not critical on its own. There is a lot of air movement in the chassis and the cpu doesn't overheat if the cooler...
- Likes 1
Leave a comment:
-
Run channel check DCP, Dolby Jiffy or similar, note any issues, back up setting BEFORE you start!
Software updates on the processor, crossover....Last edited by Pete Naples; 06-01-2024, 03:42 PM.
- Likes 3
Leave a comment:
Leave a comment: